How to Change Bathroom Taps

Changing bathroom taps is one of the most common renovation projects. Although some people prefer to leave it to the experts, it is possible to perform the task yourself, as long as you have the right tools. There are a few steps that you must follow before you begin, though. Read on to learn more about changing your taps. You will need a screwdriver and a hammer, and a knife to cut the excess sealant on the base of the tap. Be careful and do not damage the finish on the basin.

If you have an adjustable wrench, you can use it to remove the old tap. Next, make sure to clean the area around the old tap. Afterward, install the new tap and secure it with a nut and washer. If the flexible tap connector is attached to the body, you can replace it at this point, and then reconnect the new one to the old one. The process should take about five minutes. In this article, we'll show you how to change bathroom taps.

After cleaning the basin and the area around the old one, you can install the new one. The new tap should be attached to a threaded post. Next, you need to connect the new tap to the basin with flexible connectors. The fixings of the new tap will vary depending on its manufacturer. It is recommended to check the manual for instructions. And, be sure to check the installation directions carefully before attempting any task.

If you're looking for a more sophisticated look, new bathroom taps can add a stylish and modern flair to any room. Whether you prefer the traditional look of an old fashioned bathroom faucet, or are looking for a contemporary, minimalist look, changing bathroom taps is a great DIY project. Even if you're not handy with tools, using some common sense and following simple instructions can make the process less complex and more fun. Just be careful and practice safety and avoid making any mistakes that can damage the pipes.

After removing the old faucet, it's time to remove the nuts that hold the faucet in place. Most faucets are secured with locknuts that are located above the water supply line connections. To remove them, use a wrench or WD-40. Once the locknuts are removed, pull the faucet out straight and remove the gasket. A flashlight may be handy to help you locate the nuts that are stuck in the sink.

Once you've removed the old faucet, you'll need to attach the new one. Make sure you have the right mounting nuts on the faucet. If you don't do this, you'll be at risk of damaging your sink's porcelain. Be sure to keep these tips in mind when installing a new faucet. So, start changing your bathroom faucets! You'll be glad you did. Enjoy! And remember: It doesn't have to be difficult!

You may also use the same kitchen taps in your bathroom. Just make sure that the size matches the shape of the sink. It might take a bit of modification to the sink if you want to install a new tap in your bathroom. If your sink has already made holes, you won't be able to use your kitchen taps. You can also try changing your bathroom taps if they are too big for your sink.

Before installing a new faucet, you need to shut off the water supply valves under the sink and remove the drain collar and rim. Use rubbing alcohol to clean the faucet's holes. After cleaning the holes, center the new spout in the center hole and slide the flat washer over the threads. Place the new faucet into position and tighten the mounting nut with a basin wrench. You can have help with this step.

If your water meter displays red numbers, these represent individual litres. Older meters may have four digits in this group - the fourth digit represents a tenth of a litre. Make sure that the numbers are accurate. To test the accuracy of your meter, fill a 10-litre bucket. Check that the water meter reads correctly. If you notice any additional water, you may want to refill the bucket.