Eye bolts are a robust and easy‑to‑install attachment point for other rigging hardware, including slings and shackles. They are among the most widely used lifting and rigging products used by eye bolts manufacturers in Mumbai and play a key role in industrial lifting, hoisting, towing, and anchoring. Used correctly, eye bolts are a safe and durable component in rigging assemblies.
Here, carbon steel eye bolt manufacturers will show us how to install eye bolts to maximise safety and effectiveness.
Eye Bolt Installation Best Practices
According to the top eye bolts manufacturer in Mumbai, Safe eye bolt use starts before installation. Lifting eye bolt manufacturers inspect it to ensure that you have the correct eye bolt details and the eye bolt is undamaged and suitable for the job.
- Ensure the eye and the shank are free from bends or distortions.
- Verify that the eye bolt's working load limit (WLL) or rated capacity (RC) is sufficient to support the expected load and any accompanying rigging components.
- Ensure the eye bolt has not been modified or machined. According to the eye bolt manufacturer in Mumbai, removing material from an eye bolt can reduce its WLL.
- Verify that the shank's threaded section has the same thread diameter and pitch as the mating hole or nut. The best advice by forged eye bolt manufacturers is, Do not attempt to force an eye bolt into an incompatible thread.
- Ensure that the threads on the shank and receiving hole are clean and free of debris.
- Ensure the load is applied in line with the plane of the eye. You may have to use washers as shims to align the eye correctly.
Install Eye Screws: Personal Story
A personal story from eye bolts suppliers in Mumbai: I used to install hooks and eye screws by laboriously turning them into place with a screwdriver through the hole. Now I drill an appropriately sized hole, then mount a matching hook or open eye-bolt into my drill chuck, as shown in the drawing above. After hand-tightening the eye screw, I insert the hook and spin the eye screw home in seconds.
How To Install Eye Bolt In 10 Minutes
- Locate a drill bit that is smaller than the eye bolt body. To do this, first understand the eye bolt m20 dimensions and hold up the eye bolt and hold each drill bit in front of the threads. Pigtail eye bolt manufacturers recommend, the bit should be as large as the body of the eye bolt, but you should still be able to see the threads around the outside of the drill bit. If you doubt the size is correct, use one smaller.
- According to shoulder eye bolt manufacturers, locate a stud in the ceiling using the stud finder. Once you've found one that's in the approximate place you want to hang the lamp or plant, mark it with a pencil.
- Insert the drill bit into the drill, and drill the mark. Turned eye bolt manufacturers recommend that you want to drill in as deep as the bolt itself, not farther, but you can approximate this if need be.
- Place the eye bolt in the hole and start to twist it in place with your hand.
- Insert the screwdriver into the eye of the bolt and turn it until the only thing that's visible in the ceiling is the eyelet of the bolt.
Installation
This Installation technique works on the following bolts:
eye bolt with wing nut, eye hooks, eye screws, eye bolt anchors, lifting eye bolts, swivel eye bolts and anchor eye bolts M10, M10 eye bolts, M8 eye bolts, M6 eye bolts and even M12 eye bolts, shoulder eye bolts, M16 eye bolts, 1/2 eye bolts and stainless eye bolts - plus oval eye bolts and galvanised eye bolts, eye foundation bolts, forged eye bolts and stainless steel eye screws, 10mm eye bolts as well as 10mm large eyebolt anchors and Masonry eyebolts.
